Siemens SIMOCODE pro

Alarms, faults and system events
SIMOCODE pro
15-10 GWA 4NEB 631 6050-22 DS 03
*) See "Error number" in Chapter B.6 "Data record 72 - Error buffer"
Wrong password SIMOCODE pro parameters are
protected by a password.
An attempt has been made to
change the parameters without
entering the password.
Please use the correct
password for changing
the parameters.
If you do not know the
password, new
parameters can only be
entered after the factory
settings have been
restored.
For a description of
factory settings, please
refer to Chapter 14.3.4
"Resetting the factory
settings".
Event
(alphabetical)
Description Troubleshooting Acknowledg
ement/fault
rectification
Contactor
control
Error
no.*)
Table 15-1: Alarms, faults and system events (Cont.)