Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
1-66 GWA 4NEB 631 6050-22 DS 03
Safety
Safety DM-F Local Enabling circuit status, switch-off "Safety", "Safety OK."
Note
This is only displayed if the OPD version is above *E04* and if the
BU2 is above version *E07* with a DM-F Local present.
DIP switches, DM-F Local Status of DIP switch 1, 2, 3, 4, 5, 6, 7, 8.
Note
This is only displayed if the OPD version is above *E04* and if the
BU2 is above version *E07* with a DM-F Local present.
Safety DM-F PROFIsafe Enabling circuit status, switch-off "Safety", PROFIsafe active
Note
This is only displayed if the OPD version is above *E04* and if the
BU 2 is above version *E07* with a DM-F PROFIsafe present.
Table 1-12: Motor protection and motor control status (Cont.)

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000