Siemens SIMOCODE pro System Manual

System description
SIMOCODE pro
1-72 GWA 4NEB 631 6050-22 DS 03
Status display for PROFIBUS communication
The "Communication" menu item displays all important information
concerning PROFIBUS communication. In addition to the current PROFIBUS
device address, the baud rate or PROFIBUS-relevant settings concerning
process alarms and diagnostic alarms for the automation system are also
displayed.
Here are the most important menus:
PROFIBUS address (example)
PROFIsafe address Displays the PROFIsafe address.
Note
This is only displayed if the OPD version is above *E04* and if the
BU 2 is above version *E07* with a DM-F PROFIsafe present.
Baud rate
Bus o.k.
Bus monitoring
Table 1-14: Status display for PROFIBUS communication

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000