DC link components
8.6 Control Supply Module CSM
Booksize Power Units
Manual, (GH2), 07/2016, 6SL3097-4AC00-0BP8
535
Table 8- 26 DIP switch S1
1 Changeover switch, single
operation / parallel operation
Left: Single operation
Right: Parallel operation
Changing over the output characteristic
2 Dummy contact
(not used)
It is only permissible to changeover when in the no-voltage state.
Figure 8-21 DIP switch on the upper side of the component
When delivered, "single operation" is set. Both switches are set to the left.
To Next Page
Loading...
