Siemens SINAMICS SIMOTICS S200 PROFINET - Page 127

Note
Additional 󹪝xing of the cable
If
between the cable strain relief on the cable carrier and the terminal at the motor, part of the
cable is hanging loose or is not routed, Siemens recommends that the cable is additionally 󹪝xed
for vibration load and with horizontal or vertical cable entries.
• Additionally 󹪝x the cable where the motor is 󹪝xed so that machine vibrations are not
transferred to the connector.
Mounting
5.2Motor
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 125