Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

• Scenario 3: The originall
y con󹪝gured drive password is modi󹪝ed.
1 2 3
$SFBUFCBDLVQ꫼MF3FTUPSFESJWFEBUB
0SJHJOBMMZDPO꫼HVSFEESJWFQBTTXPSE
4VCTFRVFOUMZDIBOHFEESJWFQBTTXPSE
$POWFSUFS"$POWFSUFS"$POWFSUFS"
୫$IBOHFQBSBNFUFS
WBMVFT
୫$IBOHFESJWF
QBTTXPSE









– Click on "Restore".
A dialog to enter t
he password opens.
– Enter the drive password con󹪝gured in step 2.
The drive password con󹪝gured in this step di󹪜ers from the drive password with which the
drive data in the backup 󹪝le were encrypted.
A dialog to enter the password opens.
– Enter the drive password that was used to encrypt the drive data in the backup 󹪝le.
The drive data are loaded into the converter from the backup 󹪝le.
As a consequence, the status of the settings at the instant of the backup are restored.
Function "Drive data encryption" is activated. The originally con󹪝gured drive password is
applied. The drive password con󹪝gured in step 2 is then overwritten.
• Scenario 4: Before restoring, the converter is completely reset to the factory settings and a
drive password is con󹪝gured. More information about the complete reset is provided in
Section "Reset of all user-de󹪝ned settings to the factory setting via an SD card (Page587)".
1 2 3
$SFBUFCBDLVQ꫼MF
3FTUPSFESJWFEBUB
0SJHJOBMMZDPO꫼HVSFEESJWFQBTTXPSE
$POWFSUFS"
$POWFSUFS"$POWFSUFS"
୫$PNQMFUFMZSFTFU
DPOWFSUFS
୫"DUJWBUFFODSZQUJPO







– Click on "Restore".
A dialog to enter t
he password opens.
Commissioning (web server)
7.4Functions and menus
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
206 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English