Siemens SINAMICS SIMOTICS S200 PROFINET - Page 240

Only the most important data of the new converter are displayed at the center of the dialog
box in the "N
ew device" 󹪝eld. You can compare these data with the data of the current
converter (left-hand side).
If both converters are not fully compatible, then the corresponding information is displayed
in the "Compatibility information" 󹪝eld. This means that you may have to assign another
motor if you still go ahead and accept the required replacement device.
3. Click "OK" to accept the new converter.
Commissioning (Startdrive)
8.5Combining and con󹪝guring devices in t
he project
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
238 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB