• Jog
You set t
he following parameters for incremental jogging:
– Velocity setpoint (either for jog 1 or 2)
– Traversing distances (either for jog 1 or 2)
• Function status
You view the active EPOS operating mode, existing enables, and the detailed status of
individual EPOS functions.
More information
For more information about the basic positioner, see Section "Basic positioner (EPOS)
(Page368)".
For more information about conguring the basic positioner in Startdrive, see the
information system of the TIAPortal.
Commissioning (Startdrive)
8.7Conguring the conv
erter
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
282 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
