Siemens SINAMICS SIMOTICS S200 PROFINET - Page 43

3(














;
;3
;3
;
;
;
;
;
;
;
$&
* The interfaces X131 and X108 are available on S200 PN only. For more information about the motor holding brake connection
on S200BasicPN, see Section "Connecting the motor holding brake (Page139)".
① Fuse or motor starter protector ⑧ Shield clamp
② Line 󹪝lt
er (optional)
1)
⑨ 24VDC po
wer supply
③ External braking resistor (optional)
1)
⑩ STO plug
④ SIMOTICS S-1FL2 motor ⑪ SD card (optional)
⑤ Motor power cable (with brake conductors) ⑫ Commissioning device
⑥ Encoder cable ⑬ Controller (for example, SIMATIC S7-1500)
⑦ Shield plate ⑭ PROFINET to the next participant
1)
When using t
he components, mak
e sure that they are connected to the ground correctly.
Figure3-2 System components and accessories for converters with 1AC line connection
Description
3.1System overview
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 41