Table 12-5 Message classes and coding of various diagnostic interfaces
Text of the message class Number ac‐
cor
ding to
PR
OFIdrive
Diagnostics inter‐
face
Cause and remedy PN
(hex)
DS1
(dec)
Hardw
are/software fault
A hardwar
e or software malfunction was detected.
• Carry out a POWER ON for the relevant component.
• If it occurs again, contact the hotline.
• Replace device.
(1) 9000 0
Line fault
A line supply fault has occurr
ed (phase failure, voltage level...).
• Check the line supply/fuses.
• Check the supply voltage.
• Check the wiring.
(2) 9001 1
Supply voltage fault
An electronics
supply voltage fault (48 V, 24 V, 5 V…) was detec‐
ted.
• Check the wiring.
• Check the voltage level.
(3) 9002 2
DC link overvoltage
The DC link voltag
e has assumed an inadmissibly high value.
• Check the dimensioning of the system (line supply, reactor,
voltages).
• Check the infeed settings.
(4) 9003 3
Power electronics fault
An inadmissible operating s
tate of the power electronics has
been identied (overcurrent, overtemperature, IGBT failure…).
• Check that the permissible duty cycles are complied with.
• Check the ambient temperatures (fan).
(5) 9004 4
Electronic component overload
The temper
ature in the component has exceeded the highest
permissible limit.
• Check the ambient temperature /control cabinet cooling.
(6) 9005 5
Ground fault/inter-phase short-circuit detected
A gr
ound fault/interphase short-circuit was detected in the power
cables or in the motor windings.
• Check the power cables (connection).
• Check the motor.
(7) 9006 6
Motor overload
The motor w
as operated outside the permissible limits (temper‐
ature, current, torque…).
• Check the duty cycles and set limits.
• Check the ambient temperature/motor cooling.
(8) 9007 7
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
432 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
