Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Cause: During a reconnect operation (e.g. while booting or downloading - but can also occur in normal operation) a parameter was
not able to be wr
itten to.
The parameter is then reset to the factory setting.

Alarm value (r2124, interpret decimal):
Parameter number
Remedy: Not necessary.
A01550 Security: Drive data encryption invalid
Message class: Hardware/software error (1)
Message value: -
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
Cause: The password for drive data encryption (DDE) does not match the password con󹪝gur
ed in
the converter or no password was
con󹪝gured.
The DDE password protects sensitive data on the SD card.
It is not possible to transfer the data backup from the SD card.
Remedy: To be able to restore the data backup on the SD card, the DDE password must correspond to the password that was originally
con󹪝gured for t
he data backup in the original converter:
- With the SD card inserted, enter the correct DDE password in the Security Wizard of the web server and restart the
converter.
- In Startdrive, with the SD card inserted, under Online & Diagnostics, enter the correct DDE password in screen form
"Specify password for encryption of the drive data" and restart the converter.

If the data backup on the SD card is not be used:
- Remove the SD card from the converter and restart the converter.

Notice: Not observing this and continuing to work at the converter can lead to the data backup on the SD card being lost.
A01590 Drive: Motor maintenance interval expired
Message class: General drive fault (19)
Message value: Fault cause: %1 bin
Component: Motor
Response: NONE
Acknowledgment: NONE
Cause: The selected service/maintenance interval for this motor was reached.
Alarm v
alue (r2124, interpr
et decimal):
Motor data set number.
Remedy: carry out service/maintenance and reset the service/maintenance interval (p0651).
C01600 SI: STO self test failed
Message class: Safety monitoring channel has identi󹪝ed an error (10)
Message value: %1
Variant: S200 PN
Component: None
Response: OFF2
Acknowledgment: IMMEDIATELY
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
476 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English