Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Acknowledgment: NONE
Cause: Error when operating the internal SPI bus.
Alarm v
alue (r2124, interpr
et hexadecimal):
Only for internal Siemens troubleshooting.
Remedy: - Replace the Sensor Module.
- If requir
ed, upgrade the 󹪝rmware in the Sensor Module.
- Contact Technical Support.
A31903 Motor encoder: I2C-BUS error occurred
Message class: Hardware/software error (1)
Message value: %1
Component: Sensor Module Encoder 1
Response: NONE
Acknowledgment: NONE
Cause: Error when operating the internal I2C bus.
Alarm value (r2124, int
erpr
e
t hexadecimal):
Only for internal Siemens troubleshooting.
Remedy: - Replace the Sensor Module.
- If requir
ed, upgrade the 󹪝rmware in the Sensor Module.
- Contact Technical Support.
F31905 Motor encoder: Encoder parameterization error
Message class: Error in the parameterization / con󹪝gur
ation / commis
sioning pr
ocedure (18)
Message value: Parameter: %1, supplementary information: %2
Component: Sensor Module Encoder 1
Response: ENCODER
Acknowledgment: IMMEDIATELY
Cause: An error was identi󹪝ed in t
he encoder parame
terization.
It is possible that the parameterized encoder type does not match the connected encoder.
Determine the parameter number using the fault value (r0949).

Fault value (r0949, interpret decimal):
yyyyxxxx dec: yyyy = supplementary information, xxxx = parameter
yyyy = 0:
No additional information available.
yyyy = 10:
The connected encoder is not supported.
Remedy: - Check whether the connected encoder type matches the encoder that has been parameterized.
- Correct t
he parameter speci󹪝ed by the fault value (r0949).
F31950 Motor encoder: Internal software error
Message class: Hardware/software error (1)
Message value: %1
Component: Sensor Module Encoder 1
Response: ENCODER
Acknowledgment: POWER ON
Cause: An internal software error has occurred.
F
ault value (r0949, int
erpret decimal):
The fault value contains information regarding the fault source.
Only for internal Siemens troubleshooting.
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
582 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English