Siemens SINAMICS SIMOTICS S200 PROFINET User Manual

Remedy: - If necessary, upgrade the 󹪝rmwar
e in the Sensor Module to a later version.
- Contact Technical Support.
A31999 Motor encoder: Unknown alarm
Message class: Position/speed actual value incorrect or not available (11)
Message value: New message: %1
Component: Sensor Module Encoder 1
Response: NONE
Acknowledgment: NONE
Cause: An alarm has occurred on the Sensor Module for encoder 1, which cannot be interpreted by the converter 󹪝rm
w
ar
e.
This can occur if the 󹪝rmware on this component is more recent than the converter 󹪝rmware.
Alarm value (r2124, interpret decimal):
Alarm number.
Note:
If required, the signi󹪝cance of this new alarm can be read about in a more recent description of the converter.
Remedy: - Replace the 󹪝rmwar
e on the Sensor Module by an older 󹪝rmware version.
- Upgrade the converter 󹪝rmware.
F32805 Encoder 2: EEPROM checksum error
Message class: Hardware/software error (1)
Message value: %1
Component: Sensor Module Encoder 2
Response: OFF1
Acknowledgment: IMMEDIATELY
Cause: Data in the EEPROM corrupted .
F
ault value (r0949, int
erpret hexadecimal):
01: EEPROM access error.
02: Too many blocks in the EEPROM.
Remedy: Replace the module.
F32899 Encoder 2: Unknown fault
Message class: Position/speed actual value incorrect or not available (11)
Message value: New message: %1
Component: Sensor Module Encoder 2
Response: OFF1
Acknowledgment: IMMEDIATELY
Cause: A fault occurred on the Sensor Module for encoder 2, which cannot be interpreted by the converter 󹪝rm
war
e.
This can occur if the 󹪝rmware on this component is more recent than the converter 󹪝rmware.
Fault value (r0949, interpret decimal):
Fault number.
Note:
If required, the signi󹪝cance of this new fault can be read about in a more recent description of the converter.
Remedy: - Replace the 󹪝rmwar
e on the Sensor Module by an older 󹪝rmware version.
- Upgrade the converter 󹪝rmware.
F32950 Encoder 2: Internal software error
Message class: Hardware/software error (1)
Message value: %1
Component: Sensor Module Encoder 2
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 583

Siemens SINAMICS SIMOTICS S200 PROFINET Specifications

General

Brand	Siemens
Model	SINAMICS SIMOTICS S200 PROFINET
Category	Servo Drives
Language	English