Siemens SINAMICS SIMOTICS S200 PROFINET - Page 588

Component: Terminal Module (TM)
Response: OFF2
Acknowledgment: POWER ON
Cause: An internal software error has occurred.
F
ault value (r0949, int
erpret decimal):
Information about the fault source.
Only for internal Siemens troubleshooting.
Remedy: - If necessary, upgrade the 󹪝rmwar
e in the Terminal Module to a later version.
- Contact Technical Support.
System messages
12.3Faults and alarms
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
586 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB