For more information about selecting a motor, see Section "Motor selection (Page900)".
WARNING
Risk of re caused by continuous o
verload
An explosion or a re could occur if the external braking resistor is continuously overloaded (for
example as the result of a defective Braking Module). This can result in severe injury or death
and/or the enclosure could melt.
• Use only braking resistors that are intrinsically safe.
NOTICE
Damage to the converter due to its maximum load being exceeded
If the
maximum permissible continuous power, peak power or braking energy is exceeded, the
converter may be damaged.
• Only ever operate the converter within its maximum permissible working range.
Technical data
14.1Technical data of the converter
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 619
To Next Page
Loading...
Need help?
General
