• The device provides overtemperature and overload protection.
• Use copper wir
es with a permissible temperature of 75 °C for all power cables. You can also
use cables with a higher rated temperature value. It is not permissible to reduce the
conductor cross-section.
Additional requirements relating to CSA compliance:
Maximum height for CSA: 2000m.
Motor overload protection according to UL 61800‑5‑1 Ed.2
For the settings required to activate the motor overload protection according to UL 61800‑5‑1
Ed.2, see Section "Setting motor overload protection in accordance with UL 61800-5-1 Ed.2
(Page367)".
MOTION-CONNECT connection system
The recommended assignment of motors and cables can be found in Section "Device
combinations (Page56)".
Other assignments are not possible.
The technical parameters of the cables are tailored to the requirements of the motors and
veried by system tests. For detailed information, see Section "Technical data of MOTION-
CONNECT cables (Page680)".
Appendix
A.1UL Markings
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
688 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
To Next Page
Loading...
Need help?
General
