Siemens SINAMICS SIMOTICS S200 PROFINET - Page 852

Note
The time in r8400 and r8401 is used to display t
he fault and alarm times.
Possible date/time setting:
- Web server (manually)
- NTP (Network Time Protocol)
When the converter is switched o󹪜, date/time are not updated.
After the converter has restarted, the date and time that the converter was in a no-current condition applies.
r8401[0...2] Time
 Data type: Unsigned16 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Diagnostics general
Unit: -
Description: Displays the current time in hours, minutes and seconds.
Index: [0] = Hour (0 ... 23)
[1] = Minute (0 ... 59)
[2] = Second (0 ... 59)
Not
e
The time in r8400 and r8401 is used to display t
he fault and alarm times.
The time is displayed in the 24-hour format.
Possible date/time setting:
- Web server (manually)
- NTP (Network Time Protocol)
When the converter is switched o󹪜, date/time are not updated. After power on the instant of the previous power o󹪜 is
valid.
r8600[0...20] PROFIdrive PZD receive Float32
 Data type: FloatingPoint32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Con󹪝guration
Unit: -
Description: Displays the PZD (setpoints) in the Float32 format received from the 󹪝eldbus controller.
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
850 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB