Siemens SINAMICS SIMOTICS S200 PROFINET - Page 861

r9755[0...63] SI message time removed in milliseconds
S200 PN Data type: Unsigned32 Visible in: Ext
ended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Extended functions
Unit: ms
Description: Displays the relative system runtime in milliseconds when the safety message was removed.
Dependency: See also: r9753, r9754, r9756, r60044, r60045, r60048, r60049, p60052
r9756[0...63] SI message time removed in days
S200 PN Data type: U
nsigned16 V
isible in: Ext
ended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Extended functions
Unit: -
Description: Displays the relative system runtime in days when the safety message was removed.
Dependency: See also: r9753, r9754, r9755, r60044, r60045, r60048, r60049, p60052
r9776.0...4 SI diagnostics
S200 PN Data type: Unsigned32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Safety Integrated
Unit: -
Description: Displays the operating state, referred to the safety functions. The parameter is used for diagnostics.
Bit array: Bit Signal name 1 signal 0 signal 
 00 Safety parameter changed Yes No 
 01 Safety functions enabled Yes No 
 02 Safety component replaced and data save required Yes No 
 04 Safety commissioning mode active Yes No 
Note
F
or bit 00 = 1:
At leas
t one safety parameter was changed. The change only becomes e󹪜ective after a restart, which is automatically
performed after exiting safety commissioning.
For bit 01 = 1:
Safety functions have been enabled and are active.
For bit 02 = 1:
A safety-relevant component has been replaced. Retentively save (save all parameters, p0977 = 1)
For bit 04 = 1:
The safety commissioning mode is selected.
r9780[0...1] SI checksum to check changes
S200 PN Data type: Unsigned32 Visible in: S
tandard display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Safety Integrated
Unit: -
Description: Displays the checksum to track changes for Safety Integrated.
These are additional chec
ksums that are created to track changes to relevant safety parameters (󹪝ngerprint for the
"safety logbook" functionality).
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB 859