Siemens SINAMICS SIMOTICS S200 PROFINET - Page 880

Dependency: The safety message bu󹪜er is cleared by r
esetting the parameter to 0.
See also: r9753, r9754, r9755, r9756, r60044, r60045, r60048, r60049
r60100[0...4] PROFIdrive telegram display total
 Data type: Unsigned16 Visible in: Ext
ended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Con󹪝guration
Unit: -
Description: Displays the send and receive telegrams.
Index: [0] = Subslot 1: MAP
[1] = -
[2] = Subslot 3: st
andard/SIEMENS
[3] = Subslot 4: supplementary telegram
[4] = Subslot 5: supplementary telegram
Dependency: See also: r0922
Note
Value = 65534: No teleg
ram
Value = 65535: MAP "Module Access Point"
r61000[0...239] PROFINET Name of Station
 Data type: U
nsigned8 V
isible in: Ext
ended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Con󹪝guration
Unit: -
Description: Displays PROFINET Name of Station.
r61001[0...3] PROFINET IP of Station
 Data type: Unsigned8 Visible in: Extended display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or driv
e applications
Parameter group: Con󹪝guration
Unit: -
Description: Displays PROFINET IP of Station.
Appendix
A.3Parameters
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
878 Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB