Other MADI IO is named >20;! followed by the channel number, which is set by the console according to the
M
ADI link being used (See Section 7).
Input and output signals are configured separately.
‰
Touch '>C@24A to bundle and name inputs, or touch 4AB8=0B8>=A to bundle and name outputs.
&
#)$" !) (
"" #!$#""('
You may bundle sources together to allow a neater arrangement of associated channels:
‰ Touch @40B4"4E# and a pop-up appears:
‰ Select the box next to the "0<4 legend and enter a suitable title for the bundle.
‰ Press the box next to the >@<0B legend and choose from !#"#, '(&# or – this will set the number
of sources you can choose under the ><?>=4=BA legend.
‰ Simply press each component in turn and choose the appropriate physical input according to your wiring.
Note that the name of the bundle is prefixed with ! for mono, '( for stereo and for (you guessed it) 5.1, and the
components are prefixed with ' for stereo left and '& for stereo right, or for 5.1 left, & for 5.1 right, for 5.1 centre,
for 5.1 LFE, ' for 5.1 left surround and &' for 5.1 right surround. Component signals retain their physical
connection name ('= etc.), so that troubleshooting or physical overpatching may be performed easily in the
future.
‰ Press #: to make this new bundle (note that any customised component names are erased when you do this) or
touch %C8B to cancel.
‰ To dissolve an I/O bundle, touch the #"0<4A / )=3># box and then the list item you wish to remove – all
the components will become individual again.
Page 4-12 | Section 4: Configuration C10 HD Installation Guide
A: IO Configuration
To Next Page
Loading...