SpectraLink IP-DECT 200 - Page 233

14215700-IG, Edition 8.0
April 2018, Original document
233
Field
Wireless Server Configuration - Handsets (Not relevant to the Spectralink IP-DECT Server
200.
Handset sharing (Optional)
(Only visible if license loaded)
Enabled by default when Handset Sharing License is
loaded.
Disable this, if handset sharing is not to be allowed.
For more information about using handset sharing and
configuring handset login, see "Handset Sharing" on
page197.
Handset login
(Only visible if Lync/SfB + Security
(TLS, SRTP) License is loaded)
If enabled, user credentials can be entered on the handset
and no user configuration is required on the server. Use
long key press 9 to login. (System dependant).
For more information, see "Configuring Handset Login" on
page202 and Handset User Guides.
Wireless Server Configuration - Application interface
Username Enter username required to access the application inter-
face.
Max. length: 31 characters.
New password (Optional) Enter password required to access the application inter-
face.
Max. length: 31 characters.
New password again (Optional) Confirm password required to access the application inter-
face.
Enable MSF (Optional) If enabled, access to the MSF application interface is sup-
ported.
Default value: Disabled
Enable XML-RPC (Optional) If enabled, access to the XML-RPC application interface is
supported.
Default value: Disabled
Internal messaging (Optional) If enabled, internal messaging to allow handset-to-hand-
set messaging without an external application is suported.
Wireless Server Configuration - Feature codes
Enable (Optional) If enabled, feature codes for controlling features from the
handsets can be used.
Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide