Field
Multicast TTL (Optional) The TTL is used to limit the propagation of the multicast
packets across routers.
Default value: 1
Note:The TTL is configurable and it is possible to change
the value according to network topology. For more inform-
ation, see vendor specific documentation.
Default sync type (Optional) This setting controls the default sync type for new base sta-
tions connecting to the server.
Possible values: Free running, Radio or LAN.
Note: Selecting Free running will configure each base
station as a sync master. For more information, see also
Synchronization and Deployment Guide.
Default value: Radio
LAN sync transport protocol
(Only visible if license loaded)
The protocol transport layer used by PTP for LAN sync.
Possible values: Ethernet, IPv4 or IPv6.
For more information about using LAN synchronization,
see "LAN Based Synchronization (License Required)" on
page131.
LAN sync type of service (TOS/Diff-
serv)
(Only visible if license loaded)
TOS/DiffServ values can be configured for PTP packets
used for LAN sync. The values are entered in decimal.
Network priority: Packets with higher TOS/DiffServ have
higher priority on the network.
184 = critical (highest priority)
96 = flash
64 = immediate
32 = priority
0 = routine (lowest priority)
Default value: 184 (Expedited Forwarding)
To Next Page
Loading...
