STONEX R2 PLUS User Manual

Stonex R2 PLUS Total Station - User Manual 102
22. JOB Management
22.1 Storage Media Select
For R2 PLUS series, SD card slot is an standard equipment, user can record the measured data in
internal memory or SD card directly. Before your work, it is necessary select appropriate storage
media. For both memory, the file management procedures are same.
【Procedure of storage select】
1. Select [MEM] in the status mode to enter into memory
management.
2. Select “4. Storage Media Select” to enter storage media
setting screen.
3. Press F1: Internal MSD to set the internal card as current
storage media.
Or press F2: External SD to set the external SD card as
current storage media.
If the internal card is current storage media, will display
on screen right.
If the external SD card is current storage media, will
display on screen right.
NOTE
1. If the SD card is first using on the total station, when select it as storage media, “Initialing” will
take about 30s.
Storage Media Slect
[F1:Internal MSD]
F2:External SD
Meas PC 0.0
ppm 0
SD
VA 302.5432gon II
HA 0.0000gon P3
EDM OCC OFST r e c
Meas PC 0.0
ppm 0
SD
VA 302.5432gon II
HA 0.0000gon P3
EDM OCC OFST R E C
Memory
1.JOB
2.Known data
3.Code
4.Storage Media Select
5.USB

STONEX R2 PLUS Specifications

General

Brand	STONEX
Model	R2 PLUS
Category	Measuring Instruments
Language	English