STONEX R2 PLUS User Manual

Stonex R2 PLUS Total Station - User Manual 114
24. Code Management
You could edit codes in this mode. All existed codes in memory could be read for all jobs, and
the selected code could be recorded together with occupied data or measured data.
24.1 Edit Code list
【Procedure of inputting a code】
1. Select [MEM] in the status mode to enter into memory
management.
2. Select “3.Code” to enter into code management.
3. Select “1.Code Edit”, the code will display.
4. Press ▲ or ▼ key to move the cursor, and input or
correct code.
Here:
Press F1:[ ↑↓.P] key to change the function of ▲ and ▼ keys,
if it is light, press ▲ or▼ to move cursor between adjacent
codes. If it is back light, press▲ or ▼ key to move cursor
to display adjacent pages.
Press F2:[TOP] key to move cursor to first code
Press F3:[LAST] key to move cursor to last code
Press F4:[DEL] key to selected code.
NOTE:
-The codes recorded in memory could be read for all JOBs.
-50 codes can be inputted.
Memory
1.JOB
2.Known data
3.Code
4.Storage Media Select
5.USB
Code
1.Code Edit
2.Clear list
001:CODE
002:CODEA
003:CODEB
004:CODEBCD
005:CODEBDEG
006:CODEBES
007:
↑↓.P T O P LAST DEL

STONEX R2 PLUS Specifications

General

Brand	STONEX
Model	R2 PLUS
Category	Measuring Instruments
Language	English