Stonex R2 PLUS Total Station - User Manual 116
25. Warning and Error Messages
“Low Signal!”
Please accurately re-sight the target.
“Same coordinates”
The coordinates of the backsights are the same, please re-define or re-input.
“Out of value”
The difference value of coordinates is over range
“Out of range”
The stake out height is over range.
“Need 1st obs”
During missing line measurement, the observation of the starting position was not completed
normally. Sight the starting position accurately and press [OBS] to perform the measurement
again.
“Change 1st obs?”
During missing line measurement, the observation of the target was not completed normally.
Sight the target accurately and press [MLM] to perform the measurement again.
“Need prism obs”
During REM measuring, the observation of the target was not completed normally. Sight the
offset point accurately and press [MEAS] to perform the measurement again.
“No Free Space!”
There is no more space to enter data. Record the data again after deleting unnecessary data from
the JOB or coordinate data from memory.
“No data”
When searching for coordinate data or searching for code data, the search stopped either
because the item in question does not exist or the data volume is large.
To Next Page
Loading...
