Stonex R2 PLUS Total Station - User Manual 44
8.1 Area Calculation by Measured Data
【Procedure of area calculation】
1. Select F2: [MENU]/ 3. Area /2.Area.
2. Aim at the first point, and then press F4: [MEAS].
3. Press F4: [MEAS] to re-measure distance or press F1: [OK],
the measured data is set as“Pt-01”.
4. Repeat steps 2 and 3 till all points are measured one by
one. Make sure measure them clockwise or anticlockwise.
Press F2: [CALC] and the calculated area will display.
5. Press F4: [OK] back to menu mode.
To Next Page
Loading...
Need help?
General
