Stonex R2 PLUS Total Station - User Manual 69
16. Inverse
The distance and azimuth from a start point to an end point could be calculated according to
input their coordinates.
Input: Output:
Coordinate of start point: N0, E0, Z0 Distance: D
Coordinate of end point : N1, E1, Z1 Azimuth: Az
【Procedure of Inversing】
1. Press F2: [MENU] on P2 of the basic measurement mode.
2. Turn to P2, select “4.Inverse”.
3. Input coordinates of the start point, and press F3: [REC] to
record the data in the list if necessary. You could press F1:
[READ] to read the existed data. Press F4: [OK] to set.
4. Input coordinates of the end point. See the previous step.
5. The inversed value will display. Press F3: [NEXT] to continue,
press F4: [OK] back to menu mode.
To Next Page
Loading...
