Stonex R2 PLUS Total Station - User Manual 88
5.Repeat step 4 to input other road width.
6. Press [ESC] back to road calculation menu.
20.4.3 Road Calculation
After design the road, input the interval to calculate the staking points.
1. Input the interval of staking points on the road.
2. Press F4: [ENT] to calculate, “calculating” will display
until “Cal complete” appear, the program go back to
previous menu automatically.
NOTE:
If following display, it means there are some staked points exist in this file already. Press F3: [YES]
key to cover these points, or press F4:[NO] back to previous screen.
To Next Page
Loading...
Need help?
General
