STONEX R2 PLUS - Input the Start Station

Stonex R2 PLUS Total Station - User Manual 78
20.1 Input the Start Station
1. Press F2: [MENU] on P2 of the basic measurement mode,
on the page 3 select 2.Road Calculation enter road menu.
2. Select 1.Input the parameter to enter road design
menu. And then select 1.Horizontal Curve, start point
entering menu will display.
3. Enter the start point station and coordinate, press F4:
[OK] key. Road horizontal elements editing menu will
display.
Road Calculation
1.Road file
2.Input the parameter
3.Road Setout
Road Define
1.Horizontal Curve
2.Vertical curve
3.Road Calculation
HCurve/Start Point
STATION: 0.000
Np : 0.000
Ep : 0.000
Zp : 0.000
0OK0
Type EndPile
DELv LINEv CIR CURV