Stonex R2 PLUS Total Station - User Manual 50
4. Aim at the 1
st
target and press F1: [MEAS] and measured
data will display. Press F4: [OK] to accept this value.
5. Sight the 2
nd
target, press F1: [MEAS] and measured data
will display, press F4: [OK] to accept this value.
6. Input the distance from 2
nd
point to the target point and
press key {ENT}, the angle and distance of the target point
are displayed.
7. Press F1: [REC] to save;
Press F2: [NEZ] to display NEZ coordinate;
Press F3: [NO] back to step 6;
Press F4: [YES] back to offset mode.
To Next Page
Loading...
