Symbol DS7708 - Page 174

7 - 6 DS7708 2D Vertical Slot Scanner Product Reference Guide
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS, JPOS terminal enables the
transmission of code ID characters listed in Table 7-3. These code ID characters are not programmable and
are separate from the Transmit Code ID feature
. Do not enable the Transmit Code ID feature for these
terminals.
Table 7-3 Terminal Specific Code ID Characters
Code Type ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-Nixdorf
Mode B/
OPOS/JPOS
Olivetti Omron
UPC-A A A A A A A
UPC-E E E C C C E
EAN-8/JAN-8 FF FF B B B FF
EAN-13/JAN-13 F F A A A F
Code 39 C <len> None M M M <len> C <len>
Code 39 Full ASCII None None M M None None
Codabar N <len> None N N N <len> N <len>
Code 128 L <len> None K K K <len> L <len>
I 2 of 5 I <len> None I I I <len> I <len>
Code 93 None None L L L <len> None
D 2 of 5 H <len> None H H H <len> H <len>
GS1-128 L <len> None P P P <len> L <len>
MSI None None O O O <len> None
Bookland EAN F F A A A F
Trioptic None None None None None None
Code 11 None None None None None None
IATA H<len> None H H H<len> H<len>
Code 32 None None None None None None
GS1 DataBar
Variants
None None E E None None
PDF417 None None Q Q None None
Data Matrix None None R R None None
QR Codes None None U U None None
Aztec/Aztec Rune None None V V None None
MAXICODE None None T T None None
microPDF None None S S None None
GS1-Datamatrix None None W W None None
GS1-QR None None X X None None