Symbol DS7708 - Page 521

STANDARD DEFAULT PARAMETERS A - 5
SSI Host Parameters
Select SSI Host n/a n/a n/a 10-10
Baud Rate 9Ch 156 9600 10-11
Parity 9Eh 158 None 10-16
Check Parity 97h 151 Do Not Check Parity 10-17
Stop Bits 9Dh 157 1 10-18
Software Handshaking 9Fh 159 Enable ACK/NAK 10-19
Host RTS Line State 9Ah 154 Low 10-20
Decode Data Packet Format EEh 238 Send Raw Decode
Data
10-21
Host Serial Response Time-out 9Bh 155 2 sec 10-22
Host Character Time-out EFh 239 200 msec 10-24
Multipacket Option F0h 4Eh 334 Option 1 10-26
Interpacket Delay F0h 4Fh 335 0 ms 10-28
SSI Event Reporting
Decode Event F0h 00h 256 Disable 10-31
Boot Up Event F0h 02h 258 Disable 10-32
Parameter Event F0h 03h 259 Disable 10-33
Auxiliary RSM Communication
Auxiliary RSM Communication F8 05 4E 1358 Enable 11-3
Symbology Parameters
Enable/Disable All Code Types 12-8
UPC/EAN
UPC-A 01h 1 Enable 12-9
UPC-E 02h 2 Enable 12-10
UPC-E1 0Ch 12 Disable 12-11
EAN-8/JAN 8 04h 4 Enable 12-12
EAN-13/JAN 13 03h 3 Enable 12-13
Bookland EAN 53h 83 Disable 12-14
Table A-1 Standard Default Parameters Table (Continued)
Parameter SSI Number
1
Parameter
Number
2
Default
Page
Number
1
SSI number hex values are used for programming via SSI commands.
2
Parameter number decimal values are used for programming via RSM commands.