Tektronix Keithley 4200A-SCS - Page 59

Model 4200A-SCS Prober and External Instrument Control Section 3: Configure and use a Series 700 Switching System
4200A-913-01 Rev. A December 2020 3-13
Figure 42: connectpins device connections
If the OpenAll check box is selected, the connectpins action opens all crosspoints before closing
the specified pairs. This is the default and is usually the preferred behavior. However, since
connectpins only has eight field pairs, the action can only close eight crosspoints during each run.
To close more crosspoints, use multiple connectpins actions.