Model 100E Instruction Manual Getting Started
045150102 Rev XB1 39
To view and clear warning messages:
SAMPLE HVPS WARNING SO2 = 0.00
TEST
CAL MSG CLR SETUP
Make sure warning messages are
not due to real problems.
Press
CLR
to clear the current
message.
If more than one warning is active, the
next message will take its place
Once the last warning has been
cleared, the analyzer returns to
SAMPLE
mode
SAMPLE
RANGE=500.000 PPB
SO2 = 0.00
< TST TST > CAL
MSG
CLR SETUP
SAMPLE SYSTEM RESET SO2 = 0.00
TEST CAL MSG
CLR
SETUP
TEST
deactivates warning
messages
MSG
activates warning
messages.
<TST TST
> keys replaced with
TEST
key
NOTE:
If the warning message persists
after several attempts to clear it,
the message may indicate a
real problem and not an artifact
of the warm-up period
3.2.4. Functional Check
After the analyzer’s components has warmed up for at least 30 minutes, verify that the
software properly supports any hardware options that were installed.
Check to make sure that the analyzer is functioning within allowable operating
parameters. Appendix C includes a list of test functions viewable from the analyzer’s
front panel as well as their expected values. These functions are also useful tools for
diagnosing performance problems with your analyzer (Section 11.1.2). The enclosed
Final Test and Validation Data sheet (part number 04551) lists these values before the
instrument left the factory.
To view the current values of these test functions press:
RANGE
STABIL
PRES
SAMP FL
PMT
NORM PMT
UV LAMP
LAMP RATIO
STR. LGT
DARK PMT
DARK LAMP
SLOPE
OFFSET
HVPS
RCELL TEMP
BOX TEMP
PMT TEMP
IZS TEMP
1
TEST
2
TIME
SAMPLE
RANGE = 500.0 PPB
NOX = X.X
< TST
TST >
CAL SETUP
Only appears if IZS option is
installed.
2
Only appears if analog output
A4 is actively reporting a test
function
Refer to
Section
6.2.1 for
definitions
of these
test
functions.
Toggle
<TST TST>
keys to
scroll throu
h list of functions
To Next Page
Loading...
