Teledyne 100E - Page 6

Model 100E Instruction Manual
iv 045150102 Rev XB1
5.6.2. Manual on CD (Part number 045150200) ................................................. 53
5.7. Extended Warranty (Options 92 & 93) ................................................. 54
6. OPERATING INSTRUCTIONS................................................................ 55
6.1. Overview of Operating modes ............................................................ 55
6.2. Sample Mode................................................................................... 56
6.2.1. Test Functions ..................................................................................... 56
6.2.2. Warning Messages................................................................................ 58
6.3. Calibration Mode .............................................................................. 59
6.3.1. Calibration Functions ............................................................................ 59
6.4. Setup Mode ..................................................................................... 59
6.4.1. Password (PASS).................................................................................. 60
6.4.2. Configuration Information (CFG)............................................................. 61
6.4.3. Clock (CLK) ......................................................................................... 62
6.5. Setup – Analog Output Reporting Range Configuration (RNGE) ............... 63
6.5.1. Physical Range versus Analog Output Reporting Ranges............................. 64
6.5.2. Reporting Range Modes......................................................................... 65
6.5.3. Single Range mode (SNGL).................................................................... 66
6.5.4. Dual Range Mode ................................................................................. 66
6.5.5. Auto Range Mode (AUTO) ...................................................................... 67
6.5.6. Range Units......................................................................................... 69
6.5.7. Dilution Ratio....................................................................................... 70
6.6. Setup - Internal Variables (VARS)....................................................... 71
6.7. Setup - Diagnostics (DIAG)................................................................ 73
6.7.1. Accessing the Diagnostic Features .......................................................... 74
6.7.2. Signal I/O ........................................................................................... 74
6.7.3. Analog Output Step Test ....................................................................... 75
6.7.4. Analog I/O Configuration ....................................................................... 76
6.7.4.1. Analog Output Signal Type and Range Span Selection.......................... 78
6.7.4.2. Analog Output Calibration Mode........................................................ 78
6.7.4.3. Manual Analog Output Calibration ..................................................... 80
6.7.4.4. Analog Output Offset Adjustment...................................................... 82
6.7.4.5. Current Loop Output Adjustment ...................................................... 82
6.7.4.6. AIN Calibration............................................................................... 84
6.7.5. Optic Test ........................................................................................... 85
6.7.6. Electrical Test ...................................................................................... 86
6.7.7. Lamp Calibration .................................................................................. 86
6.7.8. Pressure Calibration.............................................................................. 87
6.7.9. Flow Calibration ................................................................................... 88
6.7.10. Test Channel Output ........................................................................... 89
6.8. Digital Inputs and Outputs................................................................. 90
6.8.1. Status Outputs..................................................................................... 90
6.8.2. Control Inputs ..................................................................................... 91
6.9. Setup - Communication Ports (COMM)................................................. 93
6.9.1. Analyzer ID ......................................................................................... 93
6.9.2. COM Port Default Settings ..................................................................... 94
6.9.3. COM Port Cable Connections .................................................................. 94
6.9.4. COM2 Configuration.............................................................................. 95
6.9.5. DTE and DCE Communication................................................................. 95