Tormach 1500MX - Page 11

©Tormach® 2024
Specifications subject to change without notice.
Page 11 UM10811: 1500MX Operator's Manual (Version 0424A)
For the most recent version, see tormach.com/support
TABLE OF CONTENTS
Jog in Step Mode 145
7.4.4 View the Current Machine Position 146
7.4.5 Reference the Machine 146
About Referencing 146
7.4.6 Start a Program 146
About Cycle Start 146
Cycle Start Reference 146
7.4.7 Stop Machine Motion 147
7.4.8 View the Active G-Code Modes 147
7.4.9 View the Distance to Go 147
About Distance to Go 147
7.5 Control G-Code Programs 147
7.5.1 Use the Feed Hold Function 147
About Feed Hold 147
7.5.2 Use the Feed Rate Override Function 148
About Feed Rate Override 148
7.5.3 Use M01 Break Mode 148
About M01 Break 148
7.5.4 Use the Maxvel Override Function 148
About Maxvel Override 149
7.5.5 Use Single Block Mode 149
About Single Block 149
7.5.6 Use the Spindle Override Function 149
About Spindle Override 149
7.5.7 Change the Feed Rate 149
About Feed Rates 150
7.5.8 Change the Spindle Speed 150
About Spindle Controls 150
7.5.9 Change the Tool Number 150
About M6 G43 150
7.5.10 Use a G30 Position 150
About G30 151
7.5.11 View the Tool Length 151
7.5.12 Manually Enter Commands 151
About the MDI Line DROField 151
Admin Commands Reference 151
7.5.13 Copy Recently Entered Commands 152
7.5.14 Limit G30 Moves 152
About G30 152
7.5.15 Use Feeds and Speeds Suggestions 152
Refresh DROField Values 153
Use Additional Provided Information 153
Enable Feeds and Speeds Suggestions in Conversational Routines 154
Create Tool Descriptions 154
Manually Enter Tool Descriptions 154