©Tormach® 2024
Specifications subject to change without notice.
Page 14 UM10811: 1500MX Operator's Manual (Version 0424A)
For the most recent version, see tormach.com/support
9.2.19 Select Work Offset Coordinate System (G54 to G54.1 P500) 186
9.2.20 Set Exact Path Control Mode (G61) 186
9.2.21 Set Blended Path Control Mode (G64) 186
9.2.22 Distance Mode (G90 and G91) 187
9.2.23 Arc Distance Mode (G90.1 and G91.1) 187
9.2.24 Temporary Work Offsets (G92, G92.1, G92.2, and G92.3) 187
9.2.25 Feed Rate Mode (G93, G94, and G95) 187
9.2.26 Spindle Control Mode (G96 and G97) 188
9.3 Programming Canned Cycles 188
9.3.1 Canned Cycles Reference 188
Supported Canned Cycles 188
9.3.2 High Speed Peck Drill (G73) 190
9.3.3 Cancel Canned Cycles (G80) 190
9.3.4 Drilling Cycle (G81) 190
9.3.5 Simple Drilling Cycle (G82) 191
9.3.6 Peck Drilling Cycle (G83) 191
9.3.7 Boring Cycle (G85) 191
9.3.8 Boring Cycle (G86) 192
9.3.9 Boring Cycle (G88) 192
9.3.10 Boring Cycle (G89) 192
9.4 Programming M-Code 192
9.4.1 Supported M-Codes Reference 192
9.4.2 Program Stop and Program End (M00, M01, M02, and M30) 193
9.4.3 Spindle Control (M03, M04, and M05) 193
9.4.4 Tool Change (M06) 193
9.4.5 Coolant Control (M07, M08, and M09) 193
9.4.6 Override Control (M48 and M49) 194
9.4.7 Feed Override Control (M50) 194
9.4.8 Spindle Speed Override Control (M51) 194
9.4.9 Set Current Tool Number (M61) 194
9.4.10 Set Output State (M64 and M65) 194
9.4.11 Wait on Input (M66) 194
9.4.12 Chip Conveyor Control (M231 and M233) 195
9.5 Programming Input Codes 195
9.5.1 Feed Rate (F) 195
9.5.2 Spindle Speed (S) 195
9.5.3 Change Tool Number (T) 195
9.6 Advanced Programming 195
9.6.1 Parameters 195
Parameters Reference 195
Parameter Syntax 196
Parameter Scope 196
Behavior of Uninitialized Parameters 196
Parameter Mode 196
Persistence and Volatility 196
TABLE OF CONTENTS
To Next Page
Loading...
