6-22
Service mode ＞ Service settings
[CONFIDENTIAL]
Drum heater
Contents
"On/Off" of a drum heater is set up.
If it sets to "ON",drum refresh time will become short.
Purpose
In order to improve the picture blot by high humidity.
Method
1 Enter the Service Setting menu.
2 Select [Drum heater] using the ［▲］［▼］ keys.
3 Press the [OK] key.
4 Select [Off] or [On] using the ［▲］［▼］ keys.
5 Press the [OK] key. The setting is set.
Completion
Press the [Stop] key.
Write data (USB memory data write)
Purpose
To write data into a USB memory.
Execution is possible only when a USB memory is detected..
Method
Install the USB memory before attempting to write data.
1 Enter the Service Setting menu.
2 Select [Write Data] using the cursor up/down keys.
3 Press the OK key.
4 Select the [YES] using the left select key.
5 [Data waiting] is displayed and the printer waits for data to be written.
6 When the data is sent, [Processing] appears and the data is written to USB memory. When data writing ends,
the display returns to [Ready].
Altitude adj.
Contents
Sets the altitude adjustment mode.
Purpose
Used when print quality deteriorates in an installation at the altitude of 1,500 meters or higher.
To Next Page
Loading...
