Utax P-4532DN - 9 - 2 Firmware environment commands

9-2
Appendixes ＞ Firmware environment commands
[CONFIDENTIAL]
9 - 2 Firmware environment commands
The printer maintains a number of printing parameters in its memory. These parameters may be changed permanently
with the FRPO (Firmware RePrOgram) commands.
This section provides information on how to use the FRPO command and its parameters using examples.
Using FRPO commands for reprogramming the firmware
The current settings of the FRPO parameters are listed as the optional values on the service status page.
The FRPO command is sent to the printer in the following sequence:
!R! FRPO parameter, value; EXIT;
Example: Changing emulation mode to
PCL6
!R! FRPO P1, 6; EXIT;
FRPO parameters
Note
Before changing any FRPO parameters, print out a service status page, so you will know the parametervalues
before the changes are made.
FRPO INIT command can reset all the FRPO parameters to the default settings of the printer.
(!R! FRPO INIT; EXIT;)
Items FRPO Setting value Factory
setting
Default pattern resolution B8 0: 300 dpi
1: 600 dpi
0
Default copy number C0 1 to 999 1
Page orientation C1 0: Portrait
1: Landscape
0
Default font *1 C2
C3
C5
Middle two digits of power-up font
Last two digits of power-up font
First two digits of power-up font
0
0
0
PCL font switch C8 0: HP compatibility mode (Characters higher than 127 are
not printed.)
32： Conventional mode (Characters higher than 127 are
printed.)
Supported symbol sets : ISO-60 Norway [00D], ISO-15
Italian [00I], ISO-11 Sweden [00S], ISO-6 ASCII [00U], ISO-4
U.K. [01E], ISO-69 France [01F], ISO-21 Germany [01G],
ISO-17 Spain [02S], Symbol [19M]*
*: 128 or more of the high code section can be printed with
any C8 value. But, when setting C8 value to 0, character
code 160 is not printed.
0
Print density control D4 1: Light
2: Slightly light
3: Standard
4: Slightly dark
5: Dark
3
Total host buffer size H8 0 to 99 in units of the size defined by FRPO S5 5