HD-6/HD-7
OFF
ON
1 2
3 4 5
6
English
Optional SSD HD-6
Installation Guide
Introduction
The HD-6 is an optional SSD for use with the MFPs and the page printers. Please
read this Installation Guide thoroughly so that you understand the correct
installation method. This SSD can be installed in other models using the same
installation procedure.
Packing List
HD-6 .......................................................................................................................1
Installation Guide (this guide).................................................................................1
Precautions for Handling the SSD
When handling the SSD, adhere to the following precautions.
• The SSD is delivered in an antistatic bag. To prevent any damage, briefly touch
a large metal object to ensure discharge of static electricity before removing the
SSD from the bag.
• Never touch the SSD’s connector section directly with hands.
• When holding the SSD, avoid contact with the surface of the circuit board. Hold
it at the edges.
• Do not apply undue force when installing.
Installing the
SSD
CAUTION
Before installing (or removing) the SSD, be sure to turn off the machine’s
power and disconnect the power cord plug from the AC outlet.
Formatting the SSD
After installing the SSD in the machine, the SSD must to be formatted before
used. Formatting is performed from the machine’s operation panel.
Refer to the Operation Guide for the formatting of the SSD.
Verifying Installation of the SSD
To verify that the SSD has been correctly installed, try to print out the status page.
Refer to the Operation Guide for the method for printing a status page.
To Next Page
Loading...
