VARI❋LITE® - VL3500™ WASH LUMINAIRE SERVICE MANUAL
14 02.9686.0010 0
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s), one at a time until the end of the list is
reached. To review the error messages again, it will be necessary to access them using the Status
function. (Refer to “Troubleshooting Guide” on page 15 for a list of possible causes and remedies
associated with the error messages.)
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
WARNING: As with any repairs or maintenance to Vari-Lite luminaires, service should only be
performed by a trained and qualified service technician or at an Authorized Vari-Lite Service facility.
Table 2-1: Error Messages
Display Message
OK No Errors Found
Pan/No Sens Pan sensor not found.
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Dimmer/No Sens Dimmer sensor not found.
Cyan/No Sens Cyan sensor not found.
Yellow/No Sens Yellow sensor not found.
Magenta/No Sens Magenta sensor not found.
ColWheel/No Sens Color wheel sensor not found.
ColWheel2/No Sens Color wheel sensor not found.
CTO/No Sens CTO sensor not found.
Aperture/No Sens Aperture sensor not found.
To Next Page
Loading...
