Maintenance5581−1/A1
Winterthur Gas & Diesel Ltd.
6/ 6
5. Completion
1) Refer to 0330−1, Clearance Table, Group 5552 for the axial clearances.
2) If the axial clearances are not in the specified range, loosen the round nuts on
one of the bearing covers (see the procedure in paragraph 2 step 2)).
3) Put the bearing cover in position again (refer to paragraph 4, step 17) to step 19)
and step 22) to step 25)).
4) Attach the filling piece (1, Fig. 3) to the bearing cover (5) with the two Allen
screws (9).
5) If the fuel pumps (1, Fig. 6) were not removed, do step a). If the fuel pumps were
removed, do step b).
a) Remove the holders (94566B and 94566C).
b) Install the fuel pumps, refer to 5556−1.
6) Apply sealing compound to the sealing surfaces of the covers (3, 4 and 6).
7) Install the covers (3, 4, 5 and 6) to the housing (2).
8) Set to on the oil pump.
WARNING
Injury Hazard: Before you operate the turning gear, make sure
that no personnel are near the flywheel, or in the engine.
9) Use the turning gear to turn the engine.
10) Make sure that lubricating oil flows to all lubricating points and bearings.
6
1
2
4
WCH02236
3
5
Fig. 6
2015
Camshaft and Bearing Shells − Removal and Installation
To Next Page
Loading...
