WTI TSM Series User Manual

17-9
Command Reference Guide
/E Erase Buffer
Erases data from the buffer for a specified port(s).
Notes:
• Usersarelimitedtotheportsthatarespecificallyallowedbytheiraccounts
• Eraseddatacannotberecovered.
Availability: Administrator, SuperUser, User
Format: /E[/Y] <x> [x] [Enter]
Where:
x Is the number or name of the port buffer(s) to be cleared.
To erase buffers for all ports, enter an asterisk.
/Y (Optional) Suppresses the "SURE? (Y/N)" prompt.
Example: To clear the buffer for Port 3, access the Command Mode using an account
that provides access to Port 3, and then type /E 3 [Enter].
/BOOT Initiate Boot Cycle (RSM-8R8 Series Units Only)
Initiates a boot cycle at the selected plug(s) or Plug Group(s). When a Boot cycle is
performed, an RSM-8R8 Series unit will first switch the selected plug(s) Off, then pause
for the user-defined Boot/Sequence Delay Period, then switch the plug(s) back on. The
/BOOT command can also be entered as /BO.
Notes:
• ThiscommandisnotavailableonstandardTSMSeriesandstandardRSM
Seriesunits.TheBootcommandisonlyavailableonRSM-8R8Seriesunits.
• Whenthe/BOOTcommandisusedtorebootmorethanoneplug,theBoot/
SequenceDelayPeriodswillbeappliedasdescribedinSection5.7.
• WhenthiscommandisinvokedinAdministratorModeorSuperUserMode,
itcanbeappliedtoallplugsandPlugGroupsontheRSM-8R8Seriesunit.
WhenthiscommandisinvokedinUserMode,itcanonlybeappliedtothe
plugsand/orPlugGroupsthathavebeenenabledforyouraccount.
Availability: Administrator, SuperUser, User
Format: /BOOT <n>[,Y] [Enter] or /BO <n> [Enter]
Where:
n The number or name of the plug(s) or Plug Group(s) that you intend to
boot. To apply the command to several plugs, enter a plus sign (+)
between each plug number. To apply the command to a range of plugs,
enter the numbers for the first and last plugs in the range, separated by a
colon character (:). To apply the command to all plugs allowed by your
account, enter an asterisk character (*).
,Y (Optional) Suppresses the command confirmation prompt.
Example:
Assume that your account allows access to Plug 2 and Plug 3. To initiate a boot cycle
at Plugs 2 and 3, without displaying the optional command confirmation prompt, invoke
either of the following command lines:
/BOOT 2+3,Y [Enter] or /BO 2+3,Y [Enter]

WTI TSM Series Specifications

General

Brand	WTI
Model	TSM Series
Category	Remote Control
Language	English