Xerox WorkCentre 5022 - Page 693

06/2014
9-25
WC 5022/5024
9.1.10 Tray Lock Kit
Installation/Removal
Version 1.0
9.1.10 Tray Lock Kit
Product Code
•
Installation Procedures
1. Check the bundled items. (Figure 1)
Figure 1 j0mg91026
2. Turn OFF the power switch and make sure that the screen display turns OFF.
CAUTION
When turning OFF the power switch, check that the "Data" lamp is OFF and that there is
no Job in progress.
3. Unplug the power plug.
WARNING
When maintaining the machine, turn OFF the power switch and unplug the power
plug.
4. Remove the Right Cover. (Figure 2)
a. Remove the screw (x4).
b. Remove the Right Cover.
Figure 2 j0mg91027
5. Remove the Blind Cover at the Right Cover. (Figure 3)
a. Remove the Blind Cover.
Figure 3 j0mg91028
6. Install the Lock Tray Support. (Figure 4)
a. Install the Lock Tray Support.
b. Secure it by using the screw.
Table 1
No Name Qty
1 Lock Tray Support 1
2 Tray Lock 1
3 Screw 1