CABLE ROUTING
2-60
1. Rear cylinder thermostat inlet hose
2. Right handlebar switch lead
3. Wire harness
4. Front cylinder resonator hose
5. Front cylinder intake air pressure sensor hose
6. Throttle position sensor
7. Rear cylinder intake air pressure sensor hose
8. Rear cylinder resonator hose
9. Sub-wire harness couplers
10. Fuel hose
11. Injectors
12. Front cylinder thermostat inlet hose
13. Rear cylinder intake air pressure sensor
14. Front cylinder intake air pressure sensor
A. Face the ends of the hose clamp inward.
B. Face the ends of the hose clamp outward.
C. Fasten the sub-wire harness at the white tape with
a plastic locking tie.
D. Face the ends of the hose clamp rearward.
E. Face the ends of the hose clamp forward.
F. Install the front cylinder intake air pressure sensor
hose with its white paint mark facing outward.
G. Install the rear cylinder intake air pressure sensor
hose with its yellow paint mark facing outward.
H. 0
–1 mm (0–0.04 in)
To Next Page
Loading...
