THROTTLE BODIES
7-7
Removing the intake manifold assembly
Order Job/Parts to remove Q’ty Remarks
Left side cover
Refer to “GENERAL CHASSIS” on page
4-1.
Front cylinder covers Refer to “ENGINE REMOVAL” on page 5-1.
Front cylinder thermostat inlet hose/Rear cylin-
der thermostat inlet hose
Refer to “THERMOSTAT” on page 6-4.
Throttle body Refer to “THROTTLE BODIES” on page 7-6.
1 Left side cover bracket 1
2 Ignition coil bracket bolt 2
3 Front cylinder resonator hose 1
4 Rear cylinder resonator hose 1
5 Resonator hose joint 1
6 Fuel hose 1 Disconnect.
7 Sub-wire harness coupler 2 Disconnect.
8 Intake manifold joint clamp screw 2 Loosen.
9 Rear cylinder intake manifold joint 1
10 Intake manifold assembly 1
11 Front cylinder intake manifold joint 1
For installation, reverse the removal proce-
dure.
T
R
.
.
10 Nm (1.0 m
•
kg, 7.2 ft
•
Ib)
T
R
.
.
10 Nm (1.0 m
•
kg, 7.2 ft
•
Ib)
T
R
.
.
7 Nm (0.7 m
•
kg, 5.1 ft
•
Ib)
T
R
.
.
4 Nm (0.4 m
•
kg, 2.9 ft
•
Ib)
T
R
.
.
4 Nm (0.4 m
•
kg, 2.9 ft
•
Ib)
E
1
2
6
3
8
8
4
9
10
11
5
T
R
.
.
10 Nm (1.0 m
•
kg, 7.2 ft
•
Ib)
7
To Next Page