CABLE ROUTING
2-62
1. Fuel tank overflow hose
2. Fuel tank
3. Fuel tank breather hose (fuel tank to hose joint)
4. Air vent hose
5. Sub-fuel tank
6. Fuel pump
7. Fuel hose
8. Crankcase breather hose
9. Fuel cock hose
10. Fuel cock
11. Hose joint
12. Fuel tank breather hose (hose joint to rollover
valve)
13. Rollover valve
14. Fuel tank breather hose
15. Sidestand switch lead
16. Oil level switch lead
17. Fuel sender lead
18. Fuel sender
A. Route the fuel tank overflow hose, identified by the
paint mark, over the fuel tank breather hose (fuel
tank to hose joint).
B. Do not face the ends of the hose clamps inward.
C. Install the air vent hose to the fuel tank with its
white paint mark facing downward.
D. Face the crimped section of the hose clamp
downward.
E. Install the air vent hose with its paint mark facing
upward.
F. Face the ends of the hose clamp upward.
G. Install the fuel cock hose with its yellow paint mark
facing upward.
H. Face the crimped section of the hose clamp
upward.
I. Face the crimped section of the hose clamp
downward, making sure that it does not contact the
fuel tank.
J. Face the fastener of the holder outward.
K. Be sure not to pinch the fuel tank overflow hose
and fuel tank breather hose (fuel tank to hose joint)
when installing the fuel tank.
L. Face the open ends of the holder downward.
To Next Page
Loading...
