RESULT Hex value/range Description
RESULT 1 xxxx xxxxh 32 Bit: Connection 1 ... 32
0: Connection terminated / not configured
1: Connection established
RESULT 2 xxxx xxxxh 32 Bit: Connection 33 ... 64
0: Connection terminated / not configured
1: Connection established
CN_RESET_ALL - all connections reset
This command resets all connection of the CP addressed by LADDR.
The ID parameter must be set to "0" (checked for "0").
Resetting the connection means that a connection is aborted and established again
(active ore passive depending on the configuration).
An entry is also generated in the diagnostic buffer in which the job result may be found.
RESULT Hex value/
range
Description
RESULT 1 0000 0001h The reset job was transferred to the CP successfully.
The connection abort and subsequent connection establishment of every connection
were triggered.
0000 0002h The reset job could not be transferred to the CP because the service was not started
on the CP (for example CP in STOP).
RESULT 2 0000 0000h Default
CN_CLEAR_RESET - Clear the reset ID
This command resets the reset ID (bit 15 in RESULT1) for the connection selected with
the ID of the CP addressed by LADDR.
This job executes automatically when the connection status is read (CMD = 1); the sepa-
rate job described here is therefore only required in special situations.
RESULT Hex value/range Description
RESULT 1 0000 0001h The clear job was transferred to the CP successfully.
0000 0002h The clear job could not be transferred to the CP because the service was not
started on the CP (for example CP in STOP).
RESULT 2 0000 0000h Default
CN_DISCON - connection disconnect
This command resets the connection, which was selected by ID and LADDR. The reset is
executed by means of aborting the connection.
CMD 4
CMD 5
CMD 6
VIPA SPEED7
Network Communication
Ethernet Communication > FC 10 - AG_CNTRL - Control CP 343
HB00 | OPL_SP7 | Operation list | en | 18-30 150
To Next Page
Loading...
