RESULT Hex value/range Description
0000 x000h Bit 15 ... 12: General CP information
(excluded: 0011
b
, 1011
b
)
Bit 13, 12: Connection status
(only available for SEND/RECV connections based on the ISO/RFC/TCP
protocols; with UDP, the corresponding internal information is output)
00: Connection is terminated
01: Connection establishment active
10: Connection termination active
11: Connection is established
Bit 14: CP information
0: CP in STOP
1: CP in RUN
Bit 15: Reset ID
0: FC 10 has not yet reset a connection or the reset ID was cleared.
1: The FC 10 has executed a connection reset
xxxx 0000h Bit 31 ... 16: Reserved for later expansions
RESULT 2 0000 0000h Reserved for later expansions
CN_RESET - connection reset
This command resets the connection selected with the ID of the CP addressed by
LADDR.
Resetting the connection means that a connection is aborted and established again
(active ore passive depending on the configuration).
An entry is also generated in the diagnostic buffer in which the job result may be found.
RESULT Hex value/range Description
RESULT 1 0000 0001h The reset job was transferred to the CP successfully.
The connection abort and subsequent connection establishment were trig-
gered.
0000 0002h The reset job could not be transferred to the CP because the service was not
started on the CP (for example CP in STOP).
RESULT 2 0000 0000h Default
CN_STATUS_ALL - all connections status
This command returns the connection status of all connections (established/terminated)
in the RESULT1/2 parameters (at total of 8byte of group information) of the CP addressed
by LADDR.
The ID parameter must be set to "0" (checked for "0").
When necessary, you may obtain detailed information about a terminated or not config-
ured connection using a further connection status call with CMD = 1.
CMD 2
CMD 3
VIPA SPEED7
Network Communication
Ethernet Communication > FC 10 - AG_CNTRL - Control CP 343
HB00 | OPL_SP7 | Operation list | en | 18-30 149
To Next Page
Loading...
