Parameter Declaration Data type Memory block Description
STATUS OUTPUT WORD I, Q, M, D Status code
EXT_STATUS OUTPUT WORD I, Q, M, D If an error occurs during the execution of a job, the
parameter indicates, which parameter was detected
as the cause of the error in the configuration DB.
n High byte: Index of the parameter block
n Low byte: Index of the subfield within the
parameter block
Error information
ERROR STATUS Description
0 0000h Job completed without errors
0 8181h Job active
1 80B1h The amount of data to be sent exceeds the upper limit permitted for this service.
1 80C4h Communication error
The error can occur temporarily; it is usually best to repeat the job in the user pro-
gram.
1 80D2h Configuration error, the module you are using does not support this service.
1 8183h The CP rejects the requested record set number.
1 8184h System error or illegal parameter type.
1 8185h The value of the LEN parameter is larger than the CONF_DB less the reserved
header (4bytes) or the length information is incorrect.
1 8186h Illegal parameter detected. The ANY pointer CONF_DB does not point to data block.
1 8187h Illegal status of the FB. Data in the header of CONF_DB was possibly overwritten.
1 8A01h The status code in the record set is invalid (value is >=3).
1 8A02h There is no job running on the CP; however the FB has expected an acknowledg-
ment for a competed job.
1 8A03h There is no job running on the CP and the CP is not ready; the FB triggered the first
job to read a record set.
1 8A04h There is no job running on the CP and the CP is not ready; the FB nevertheless
expected an acknowledgment for a completed job.
1 8A05h There is a job running, but there was no acknowledgment; the FB nevertheless trig-
gered the first job for a read record set job.
1 8A06h A job is complete but the FB nevertheless triggered the first job for a read record sets
job.
1 8B01h Communication error, the DB could not be transferred.
1 8B02h Parameter error, double parameter field
1 8B03h Parameter error, the subfield in the parameter field is not permitted.
1 8B04h Parameter error, the length specified in the FB does not match the length of the
parameter fields/subfields.
1 8B05h Parameter error, double parameter field.
1 8B06h Parameter error, the subfield in the parameter field is not permitted.
VIPA SPEED7
Network Communication
Ethernet Communication > FB 55 - IP_CONF - Progr. Communication Connections
HB00 | OPL_SP7 | Operation list | en | 18-30 169
To Next Page
Loading...
